OCD Clone

Fulltone OCD Clone DIY kit Recorded with Arturia Audio Fuse Studio (integrated reamp function) Pedal run at 9V L=Level G=Gain T=Tone HP=High Peak LP=Low Peak Controls according to OCD original manual: HP/LP switch: Set to HP (High Peak) you get increased increased distortion throughout the Drive Knob's range, more volume, and a slight increase in the midrange (between1-2 Khz) for more of a "British" vibe (ala Vox and Marshall) Set to LP (Low Peak) you get incredible accuracy to the original sound of your Guitar and amp...very little coloration! Excellent for Clean Boosting, for cranked Blackface or Tweed-style ones, and for when you're not going for a British type sounds. Tone Knob: This knob only affects the high frequencies, you'll find that 12 o'clock position is very much neutral, turn it CCW (counter clockwise) to 10 o'clock or so forsmoother high-gain lead sounds (with Drive knob higher than 12 o'clock) or turn it clockwise for more cut, and a less compressed feel. Drive Knob: Turn this Clockwise (CW) for more distortion, keep below 10 0'clock for cleaner sounds and for boosting your amp's input without changing your basic tone. Volume Knob: Controls the amount of signal that exits the pedal. The OCD has about 20dB of available gain (more in HP mode) so don't be surprised if you end up running the Volume control at around 9 o'clock to get unity gain. "OoHSeeDee" Kit purchased from musikding.de (now available here: https://www.uk-electronic.de/onlineshop/product_info.php?products_id=2120) Based on the original Fulltone OCD schematic (probably version 1.4/1.5/1.6 or 1.7)