ART Solo MPA

Here are a few captures of my much-loved ART preamp. I deliberately chose not to include any built-in low-cut or EQ settings in order to keep the preamp’s actual output relatively raw. As far as I know, the Solo MPA’s Tilt EQ is set to 1k, so if you want to replicate this behavior later, you can use that as a guide. The captures include various gain and voice settings. For each of the following gain levels: Gain 0, Gain 9, Gain 20, and Gain 40, I’ve included the most important voice settings: Solid State, 50-50 (which is, obviously, an evenly split blend between Solid State and Tube) and Tube, without making the captures unnecessarily complex, while still leaving enough room for experimentation and adequately capturing the differences. A Harrison Flex 10 was used as the interface between MPA and DAW. These are my first published captures, and I hope someone will enjoy them. Cheers!