Pedal PCB Tyrian Distortion Aggression Red (Revv G3 Clone)

Huge Thanks goes out to Danimae Vossen for helping me train these models and to Steve Ack for feedback on getting a better model when training. Here's 3 packs based on the 3 Aggression modes of the Pedal PCB Tyrian distortion, the red has more of an upper mid/ high gain response making it tighter. All captured with Vol @ 1:00 Low Gain @ 9:00 (any lower and the red/blue doesn't sound too great) Mid Gain @ 12:00 Hi Gain @ 1:30ish (any higher the high eq gets squealy and Drive gets mushy) EQ doesn't interact with itself too much other than purely lowering/raising its set frequencies, so I captured many different settings to hopefully work with whatever model/ amp sim you're using. The pedal is pretty dependent on the Clean amp you are using. Signal Chain: Audient ID14 Main Out DIYRE L2A Passive Reamplifier Tyrian Distortion Radial J48 (-15 Pad) Audient ID 14 Balanced In Standard 400 epochs Fit_cab True /Cab Modeling Turned on (helps get the highs right) Reamp chain wasn't calibrated accurately, matched the DI of v3_0_0.wav through my chain before capturing, learnt how to calibrate after and tested with what I had recorded with before moving the gain knob on my interface and it's close. * Had to re-record Tyrian Distortion - 656 - Mid Gain - Red due to issues in the raw recording, this one was properly calibrated to my set up, but more vol since I had to reset the pedal, the added vol doesn't change the overall sound of the pedal.