Tube Works MosValve RT-2100 (LiveSPICE2NAM)

[REUPLOAD] The original schematic files have been redone for better readability and to fix the overall voicing because I felt like they never really sounded right even though the behavior and controls are fine. Turns out that I needed to change the voltage supply for both the tubes and op-amp and remove one extra op-amp stage after the Master Volume control from each channel. It's still a dark sounding amp but it doesn't sound like a wet blanket was put on the high frequencies anymore. The overhaul is largely substantial tthat I feel the reupload is warranted rather than uploading the new captures into the old tone pack webpage. --- Tube Works MosValve RT-2100. A desert rock legend, famously used by Josh Homme during his tenure with Kyuss. ・Clean Channel. Very capable of crunch sounds as well. ・Drive Channel. Also with Stack circuit engaged, which is an additional tube stage circuit similar to the B.K. Butler Tube Driver. 　。Due to the interactivity between the Drive and Stack gain controls, three captures are provided for the Drive channel with the Stack switch engaged; Drive & Stack at 5 (noon), Drive at 1 (8 o'clock) & Stack at 9 (4 o'clock), and Stack at max. This covers the different distortion textures and the range of gain available [LEGEND] ・CLN - Clean channel ・DR - Drive channel ・ST - Stack switch [NOTES] ・All the models are captured with 8x oversampling and 64 iterations for the highest quality possible. ・All controls are flat so you can hear the amp as it is with neutral settings. I may add additional captures with "ideal" settings, but that's not a priority for now.. 　。Only exception to this is the Drive channel with the Stack switch engaged. Three captures of it with the Drive & Stack controls at 5 (noon), Drive control at 1 (8 o'clock) & Stack control at 9 (4 o'clock), and Stack at max are provided to cover the different distortion textures and range of gain available. ・Should you wish to push more gain into the captures, use a separate gain utility/plugin and a clipper/waveshaper/limiter with a ceiling of -0.1dB or less before your NAM loader to prevent nuking the models if the input signal gets too hot. === LiveSPICE: https://livespice.org/ Original LiveSPICE .schx schematic file: https://github.com/MARKTHERENCE/LiveSPICE-MK-Circuits